Seat - Coleman SK100 Go-Kart

Bucket Seat for Coleman SK100

This is a hard plastic bucket seat for the Coleman SK100 go-kart.  It fits other makes and models of go-karts and drift trikes too.  Please check pictures and measurement to see if it fits your application.

Seat specs:

• Width: 17.75 inches at the widest point
• With the seat sitting on the floor the back is just over 12.0 inches high
• With the seat up against the wall, the seat extends to almost 18.0 inches
  
• The seating surface is about 13.5 inches on the inside of the seat
• The back is about 11.0-12.0 inches on the inside of the seat
• The bolt holes at the front of the seat are 9.67 inches center-to-center apart
• The bolt holes in the bottom rear of the seat are 9.6 inches center-to-center apart
• The bolt holes in the top back of the seat are 7.7 inches center-to center apart
• The distance from the front bolt holes to the bottom rear bolt holes is 10.7 inches apart center-to center
• The distance from the bottom rear bolt holes to the top back bolt holes is 7.9 inches center-to-center apart
• Bolt holes are big enough for 6mm bolts
• Slots for seat belt in middle of seat back.  Slots are approximately 3/4 in. x 3 in.
  
• There are also three small holes in rear of seat to get rid of water if necessary
• This seat is specifically used on the Coleman SK100 single seat go-kart
• On the SK100 this seat bolts into the seat frame
• FS-30020

Shipping details:

Do you need your seat fast?  If you order before 3:00 pm CST, Monday thru Friday, your order goes out the same day.   Buy now!